Two Step Toker Unboxing
Koala Puffs Approved!
Instructional Videos
FILLING THE TWO STEP TOKER
- Place the cylinder into the SMOKE position.
- Turn the Two Step Toker upside-down revealing the bottom plate.
- Slide the bottom plate exposing the herb storage chamber (the largest chamber in the middle).
- We recommend using a piece of paper to funnel dry herbs into the storage container.
- Once the dry herbs have been poured into the storage container, slide the bottom plate back into the Two Step Toker.
FILLING THE BOWL
- Start with the rotating cylinder in the SMOKE position.
- Flip the Two Step Toker upside-down and rotate the cylinder into the LOAD position.
- Gently tap the bottom of the Two Step Toker to pack the bowl.
- Rotate the cylinder to the SMOKE position to trap the dry herbs in the bowl.
- Flip the Two Step Toker right-side up.
USING THE STEM
- Unzip the Two Step Toker’s case to unveil the retracted stem.
- Use a finger to extend the stem into smoking position.
- After smoking, return the stem into its retracted position and zip up the case.
INSTALLING YOUR LIGHRER
- The Two Step Toker is engineered to perfectly fit your favorite BIC Classic lighter to keep your dry herbs, smoking device, and lighter all in one unit.
- Insert your BIC Classic lighter into the designated lighter slot.
- Push the BIC Classic lighter down to click it into place.
THE PLUG
- The Two Step Toker includes a red stopper that plugs the chamber. The stopper ensures that none of your dry herbs leave the chamber when the Two Step Toker is not in use.
- Please remove the red stopper removing the lighter or before smoking.
- After smoking, insert the red stopper to keep loose herbs from escaping into your pockets or purse.
INSTALLING THE WINDSHIELDS
- The Two Step Toker comes with a pair of steel windshields which makes smoking outdoors, in breezy and windy conditions much easier.
- With or without the lighter inserted, slide each windshield into the slots found inside the lighter compartment.
- Directly slide each windshield into its slot, or insert the windshield at a 45° angle and twist it into place (as seen in the video).
CLEANING THE TOKER
- Cleaning the Two Step Toker is easy and takes only 10 minutes!
- Open the cylinder cover and remove the cylinder. Remove the mesh screen from the bowl.
- Remove the stem and cylinder cover by extending the stem and gently pushing it up and off of the Two Step Toker body. Detach the stem from the cylinder cover.
- Place the cylinder, mesh screen, stem, and cover into a container and cover in 91% isopropyl alcohol. Let the pieces soak for at least 5 minutes. Use a Q-tip while soaking to help release and break up resin. Use the included pipe cleaners to clean the pipe stem.
- Once clean, wipe all surfaces dry with a paper towel and re-assemble the Two Step Toker. If you need a new screen, you have extras stored in the bottom of the pipe!



